Started work on the dinette table. The PO had covered the original yellow and gold flecked Formica with a thin white cheapo formica type stuff. You can see from the picture below there is quite a bit of glue still on the yellow Formica even after I scraped a bunch off...
This sucks. Thats all I can say...
A picture of nails? Yeah. This is something that should NOT be used anywhere near aluminum trim. Ring shank nails. WHY!?!?! Some days I wonder where some folk's heads are. Once they laid down the crappy white Formica stuff they reattached the trim piece with ring shank nails. As
Red Dirt would say... this does not make me happy...
Once I got the aluminum trim off the top Formica comes right off. It is glued to Masonite. The Masonite is not attached to the plywood table. I found this logo. From what I can tell is that
Roseburg is still in business but they don't make Resin-TITE anymore. I don't know why but I love finding stuff like this...
I spent some time with a scraper and a whole lot of Goo Gone. There is a few problems that need to be addressed...
There is a few deep scrapes and the dark spots. I tried to get the spots off but they aren't going anywhere. The gold flecks that are at the surface actually rust.
I think the dilemma here is that we actually want the original Formica if we can keep it. We dig the vintage aspect of owning a vintage trailer. So keep the chewed up Formica or replace it? Thats the dilemma...
If we decide to keep the original it needs some protection. I was thinking of getting some of that 2 part epoxy that is made for bar tops. If it was nice and thin it could serve as good protection and fill some of those deep nicks and scratches. It won't get rid of the dark spots but maybe the dark spots add to the character. Maybe not. Maybe a material replacement is the better route. Anybody have any ideas? Let me know.
The table leg is a bit chewed up also. The damage is from a eye bolt in the floor. Not sure how to remedy this. I may sand the whole leg and turn it around so the deep scratches are facing the rear. That or replace the whole leg with new wood...
I'm also not real excited about this aluminum hinge on the leg. It isn't the most secure and a bit bent up. I bought a new heavier hinge to swap this one out. I also have to sort out a way to hold the leg in the down position without that stupid eye bold in the floor...
Even the aluminum trim was a pain. It is so big and awkward that polishing is a pain. But it is done. The areas around every hole is sorta messed up from pounding in those nails...
I need to come up with a few solutions before I move forward on the table. I will keep everyone posted.
Posts
